Please call  01473 735005 or email us for the best delivery price on any of our Jumps. Games, Dressage, Markers & Mounting steps can be purchased online.

    Christmas Saver with up to £400 off Click here for full details. 

Front facing bull assembly

To keep delivery cost to a minimum when we send Bull with a courier there is an element of self assembly, 

The frame feet should already have the brackets attached as shown below. If not, it may have been to reduce packaging further, so simply screw them in place around the halfway point.

Stand feet with brackets fitted

Next fit the frame.
Position the frame with the shortest sides top and bottom, giving you the tallest rectangle. Make sure the frames lines up with the outside edges of the frame feet. Screw through the brackets to hold the frame in place. You may find this easier to do on a by laying flat on a work table or similar, a bale could do the job.

Screw rectangular frame onto the frame feet brackets

Flip the stand over so you can work on the side without the brackets. Lay your bull flat on top of the rectangular frame with his hooves flush with the bottom. Screw in place. The Bull is not pre drilled as it doesn't matter too much where the screws go through to the frame but see photo below as a guide.

Screw the bull to the front of the frame. Position with his feet at the bottom

Finally position the holder in place and screw through the predrilled holes on both sides of the holder.

Screw the hoop holder in place

Done and ready to go.

Front facing bull assembled

If you have a two piece Bull the process is the same as above but you have a hinged Bull and the fame is a different shape. See below

Two piece Bull assembled